Description
Introduction
The 36HS2418CL6 is a two-phase Nema 14 step motor 13Ncm 1.8A that has a step angle of 1.8° (200 steps/rev). It comes with a connector for easy installation. Each phase draws 1.8 A at 3.48 V, which enables a holding torque of 13 Ncm. The motor has four color-coded wires: black and green represent one coil; red and yellow represent the other. The 36HS2418CL6 stepper motor can drive a pair of matching H-bridges (one for each coil), but we recommend using a bipolar stepper motor driver.
How to connect Nema 14 stepper motor with a driver?
As shown in the diagram below, there are four different colored wires viz. red, green, black and yellow. The wires are connected to two different coils. Black and green are connected to one coil and red and yellow to the other. The logical sequence of power supply to the coils allows the motor to rotate.
The 36HS2418CL6 Nema14 stepper motor is compatible with the following drivers, among others:
You are always welcome to contact us if you need help. We will be happy to help you.
Specifications
Serial model | 36HS2418CL6 |
A step | 1.8 ± 5% ° / step |
Rated voltage | 3.48V |
Nominal current | 1.88 A / phase |
Phase resistance | 1.85 ± 10% ohm / phase |
Phase inductance | 1.05 ± 20% mH / phase |
Holding torque | 13 Ncm min |
“Detent” torque | 0.5 Ncm max |
Rotor inertia | 6 g-cm² |
Number of wires | 4
Black: A+, Green: A-, Red: B+, Yellow: B- |
Shaft diameter | 2.5mm, gear mounted |
Motor length | 19 mm |
Possibilities of use
The Nema14 stepper motor is used in applications that require low torque.
Reviews
There are no reviews yet.