Nema 23 stepper motor with reducer 1:15 3.0A

Key Features:
  • Brand: ACT Motor
  • Step angle: 1.8 °
  • Rated current/phase: 3.0 A
  • Rated voltage: 1.65 V
  • Phase inductance: 2.0 mH
  • Phase resistance: 0.55 Ω
  • Holding torque: 1.4 Nm (without reducer)
  • Detent torque: 6.8 Ncm
  • Shaft diameter: 8 mm
  • Motor length: 76 mm

48,90

7 in stock
SKU 472-Z-1-16
Brand
Add to wishlist Add to compare

Description

Introduction

23HS8430AG15-P is a two-phase Nema 23 step motor with a reducer, which has a step angle of 1.8 ° (200 steps / revolution). Each phase draws 3.0A at 1.65V, allowing a holding torque of 1.4Nm, which increases proportionally when using a 1:15 reducer. The motor has four color-coded wires: yellow and white represent one coil; red and blue represent the other. We use a bipolar stepper motor driver to control the 23HS8430AG15-P stepper motor.

How to connect 23HS8430AG15-P Nema 23 stepper motor with reducer with driver?

Bipolar stepper motors require a special driver circuit called an H bridge. 23HS8430AG15-P is compatible with to the DM542 driver and 36 In switching power supplies.

As shown in the wiring diagram, there are four wires of different colors viz. red, green, yellow and blue. These wires are connected to two different coils. Red and blue are connected to one coil and yellow and white to another. To rotate the motor, the coils are energized in a logical sequence.

Nema 23 step motor

If you need help connecting, you can always contact us. We will be happy to help you.

Nema 23 bipolar stepper motor with reducer and its characteristics:

  • High torque
  • Smooth movement
  • High efficiency
  • Energy saving
  • Low noise level
  • Minimal vibrations
  • High torque
  • Low starting current
  • Reliability.

Specifications:

Series
Model
23HS8430AG15-P
Frame size Nema23
A step
(°)
1.8
Motor length
(mm)
76
Rated voltage
(V)
1,65
Nominal current
(A / phase)
3,0
Phase resistance
(Ω)
0.55 ± 0.1
Phase inductance
(mH)
2.0 ± 20%
Holding torque
(Nm Min)
1.4 (without reducer)
“Detent” torque
(N. cm Max)
6,8
Rotor inertia
(g.cm²)
480
Shaft Single D shaft
Shaft diameter
(mm)
8.0 ± 0.012
Number of wires
(No.)
4

Red A +, Blue A-, Yellow B+, White B-

Reduction ratio 1:15
Engine weight (without reducer)
(d)
1050

Specifications

Brand

Step angle

1.8 °

Case size

Nema 23

Number of phases

2

Rated current/phase

3.0 A

Rated voltage

1.65 V

Phase inductance

2.0 mH

Phase resistance

0.55 Ω

Holding torque

1.4 Nm (without reducer)

Detent torque

6.8 Ncm

Rotor inertia

480 gcm²

Shaft diameter

8 mm

Number of wires

4

Motor length

76 mm

Brand

ACT Motor

Reviews

There are no reviews yet.

Write A Review

Your email address will not be published. * represents mandatory fields.